Minebea Intec CAW2P, Руководство по эксплуатации

Страница: 29 / 224

- Pin Assignment Chart (see chapter 4.2.8.2 )
An Minebea Intec platform (CAAPP, CAAPS) is connected at the factory to the Combics
indicator WP1 input.
NOTICE
Loss of warranty is possible.
Any installation work that does not conform to the instructions in this manual results in
forfeiture of all claims under the manufacturer’s warranty.
The load cell should be connected by a certiied technician who has received
specialized training from Minebea Intec.
Peripheral devices should be connected by a certiied technician who has received
specialized training from Minebea Intec.
CAUTION
Property damage and/or personal injury are possible.
Disconnect the equipment from the power supply before starting connection work.
CAW2S (IP69K)
4.2.7.1 Assembling connection and interface cables
The cable screw connection (IP69K protection) is pre-assembled on the .
NOTICE
Risk of property damage
Carefully perform all work on the screw connection.
Be sure to use a torque wrench. The torque of this cable screw connection is
5 Nm .
. Place cables from peripheral devices next to the indicator.
. Opening the Combics indicator: Loosen the ten cap nuts on the front panel. Remove
the front panel.
4 Device installation Combics 2 Series Complete Scales Models CAW2P, CAW2S
Minebea Intec EN-27