Minebea Intec CAW2P, Руководство по эксплуатации

Страница: 138 / 224

Note:
If automatic printout of results is enabled, you do not need to press the key.
The results are printed automatically. Printout coniguration, see chapter 7.16 .
pRef + 20 %
wRef + 0.085 kg
G# + 1.080 kg
T + 0.675 kg
N + 0.423 kg
Prc + 100 %
-------------------
7.11 Checkweighing application
With this application "Checkweighing" , you can check whether the sample on the
weighing platform matches a target value or lies within a given tolerance range.
Checkweighing also makes it easy to ill sample materials to a speciied target weight.
Menu: [APPLIC.] - [APPLIC.2] - [CHECK.WG] (see chapter
6.1.2.1 ).
Features
-
Enter the nominal or target weight (set point) and the tolerance range delimiters
either using the keypad or by saving the weight value of a load on the platform.
- Enter the tolerance limits as absolute values (Min and Max), as a percentage deviation
from the target or as a relative deviation from the target.
Setting: [APPLIC.] - [APPLIC.2] - [CHECK.WG] - [CHECK.RG] (4.2) (see chapter
6.1.2.1 ).
- The target value can be taken over as a weighed value from a weighing platform, and
the upper and lower tolerance limits are deined as a percentage deviation from the
target value (menu item [INPUT] - [TARG.PER] 4.5.2). The following percentages can
be selected as the deviation: 0,1%, 0,2%, 0,5%, 1%, 1,5%, 2%, 3%, 5% or 10%, selection
using the
key.
- The target value, lower tolerance limit (minimum) and upper tolerance limit
(maximum) can applied as weighed values from the weighing platform (menu item
[INPUT] - [TAR.MN.MX] 4.5.1).
- The target value can be applied as weighed values and via asymmetrical percent
limits (menu item [INPUT] - [TAR.A.PER] 4.5.3).
6. Print the results with key.
Combics 2 Series Complete Scales Models CAW2P, CAW2S 7 Operating
EN-136 Minebea Intec