Minebea Intec CAW2P, Руководство по эксплуатации

Страница: 53 / 224

— HND.EXT.G 1.18 - Manual entry of the external weight
— CAL.JUST 1.18.1 - Cal/adj weight
— LIN.GEW.1
1.18.2 - Linearization weight 1
1)
— LIN.GEW.2
1.18.3 - Linearization weight 2
1)
— LIN.GEW.3
1.18.4 - Linearization weight 3
1)
— LIN.GEW.4
1.18.5 - Linearization weight 4
1)
5.6.3.1 Displaying the geographical values during the calibration procedure
Note:
The set geographic values are displayed during the calibration procedure if the display
of this data is activated in the setup menu at [BETRIEB].
Menu: [SETUP]- [BETRIEB]- [PARAMET]- [ANZ.GEOG]- [EIN] (8.12.1) (factory setting:
[AUS] 8.12.2, display deactivated) (see also Chapter 6.3.8.1 ).
When the display is activated, the calibration procedure is as follows:
After starting the calibration procedure, when using local altitude and latitude, [CAL] ,
the word [ALTITUD] followed by the set altitude (in meters above sea level) appears
briely on the display.
5.6.4 Entering calibration and linearization weights
Enter the calibration and linearization weights.
Setup information
-
To enter the linearization weights (menu items [LIN.GEW.1] 1.18.2 … [LIN.GEW.4]
1.18.5), the service mode must be activated (see Chapter 5.6.2 ).
- You can enter the calibration and linearization weights in the Setup menu for the irst
weighing platform under WP-1 and for the second weighing platform under [COM1]-
[WP-2], [UNICOM]- [WP-2] or [COM-WP]. The settings are applied in the
corresponding number menu under the menu item [HND.EXT.G] 1.18.
- Activation of the service mode is not required in order to enter the external user
calibration weight under menu item [CAL.JUST.] 1.18.1.
- The calibration and linearization weights must be entered in the unit selected in the
ADC coniguration under menu item [EINHEIT] 11.7, see Chapter 6.6 ).
Menu tree for entering the calibration and linearization weights
Menu: [SETUP]- [WP-1]- [INTERN.]- [PARAM.1]- [HND.EXT.G] (1.18) (see also
Chapter 6.3.1.1.1 ).
1. Conirm the value displayed with the key (cancel with the key).
The word [LATITUD] is then briely displayed followed by the set latitude in
degrees.
2. Conirm the value displayed with the key (cancel with the key).
Then the prompt to place the calibration weight onto the scale is displayed. If the
gravitational acceleration has been entered instead of the local altitude and
latitude, the word [GRAVITY] appears briely followed by the set value for the
gravitational acceleration.
3. Conirm the value displayed with the key (cancel with the key).
5 Getting started Combics 2 Series Complete Scales Models CAW2P, CAW2S
Minebea Intec EN-51