Midea MFH180-G1302DS F01E-EU, Техническое обслуживание руководство

Страница: 41 / 62

– 4 4 –
(Continued Next Page)
Thermistor
Hex-Head Nut
Heater Assembly
The heater assembly is located above the pump,
and is accessed from the front of the washer.
The heater assembly consists of a heating
element and a water temperature thermistor.
The heater can operate in whites, or stain wash
cycles, and when sanitize wash temperature is
selected.
The heater assembly is held in place by a
bracket attached to the inside of the outer tub
and a 10-mm nut which compresses a rubber
gasket to the tub opening.
When the 10-mm hex nut is tightened, it
squeezes the rubber gasket between 2
mounting plates to seal the heater assembly to
the opening of the tub.
The hex nut is set from the factory at 31 in. lbs
of torque.
Speci fi c failures as sociated with the heater
assembly can initiate error codes E34 and
E
36
. (See
Service Test Mode
.)
•
•
•
•
•
•
Heating Element Specif cations:
120 VAC
970 Watts
Approximately 8 Amps
Approximately 15
Ω
Thermistor Specif cations:
12 K
Ω
at 75°F (24°C).
Resistance goes down as temperature goes up.
To remove the thermistor:
Remove the service panel. (See
Service Panel
.)
Drain the washer using the pump cleanout. (See
Pump
.)
Disconnect the wire harness from the thermistor.
Loosen the 10-mm hex nut until it is fl ush with
the end of the stud.
Push inward on the 10-mm hex nut to relax the
rubber gasket.
Grasp the thermistor and pull outward.
•
•
•
•
•
•
1.
2.
3.
4.
5.
6.
Thermistor Removal
Thermistor