Midea MFH180-G1302DS F01E-EU, Техническое обслуживание руководство

Страница: 55 / 62

Service Test Mode
The washer control has a service test mode that can be utilized by the service technician in order to
test critical components and to access error codes. This test mode will help the service technician to
quickly identify failed or improper operation of washer components.
Caution: Testing is accomplished through built-in test procedures. Unplugging components for testing
can damage component connections.
Machine must be in Standby mode before entering test . If the cycle is interrupted, the washer will drain
water when the power is re-applied. The water must been empty BEFORE the test mode can be entered.
If water remains in the washer, manually drain the washer to empty. A failed water level switch can cause
an inability to enter the test mode.
To enter the test mode: To exit the test mode:
1. Press the Power button .
2. Press WATER PLUS button .
3.
4 .
1. Press Power button.
Note: Attempting to exit the service mode by
disconnecting the power will result in a locked
washer.
Test Mode Description
t01 Model Number Veri fi es (or sets on new board) the proper model id
t02 Error Codes Lists up to 10 control-detected problems
t03 SW Version
Verifies main control and inverter SW Version
t04 UI test Veri fi es that all displays and buttons work
t05 Pump Test Verifies pump works
t06 Water level sensor test Verifies water level sensor works
t07 Heater and NTC test Verifies heater and ntc works
t08 Water vavle test Verifies Water vavle works
t09 Tumble test Verifies the inverter and motor works
t10 Spin Test Verifies the inverter and motor works
–
5 8
–
5 Press the EXTRA RINSE button .
Press WATER PLUS button .
Press EXTRA RINSE button .