Midea MFH180-G1302DS F01E-EU, Техническое обслуживание руководство

Страница: 52 / 62

1 0 . Disconnect the heater assembly wires.
1 1 . Remove the plastic wire tie that holds the heater
assembly wiring and the tub ground wire to the
outer tub.
1 2 . Remove the front dampers from the outer tub.
(See
Dampers
.)
1 3 . Remove the 23 (8-mm) hex-head screws
from the perimeter of the outer tub.
.
1 4 . Remove the outer tub front half.
Note:
• Install new outer tub seal whenever tub halves
have been separated. Use a torque wrench to
tighten the 2 3 tub screws to 45 in.lbs of torque.
• When installing outer tub front half, ensure
heater is inserted inside the bracket attached
to the rear half of the outer tub. (See
Heater
Assembly
.)
1 5 . Pull the wash basket out of the outer tub rear
half.
–
5 5
–