Midea MFH180-G1302DS F01E-EU, Техническое обслуживание руководство

Страница: 25 / 62

– 25 –
Operation Overview
Basic Wash Cycle
Note:
See
Component Locator Views
for identi fi cation
and location of washer components.
After a load is placed in the wash basket, the user
opens the dispenser drawer and positions the
detergent selector for the type of detergent to be
used.
Detergent is added to the detergent compartment.
Detergent is added to the prewash compartment
only if prewash cycle is selected.
Note:
The prewash compartment is only fl ushed
with water when the PRE WASH option is selected
on the control.
If desired, add a measured amount (1/3 cup or less)
of bleach into the bleach compartment.
If desired, add the recommended amount of fabric
softener in the fabric softener compartment and
dilute with water to the maximum
fi ll line.
After adding laundry products, slowly close the
dispenser drawer.
The user presses the POWER button to activate the
display. If the display is active, press POWER button
to put washer into standby mode.
Rotate the cycle knob to the desired wash setting.
Select EXTRA RINSE and PRE WASH options. Use the
SIGNAL button to change the volume
on or off
.
Select the SOIL LEVEL to increase or decrease wash
time needed to remove different amounts of soil.
Select the SPIN SPEED to change the fi nal spin speed
of the cycles. Follow the fabric manufacturer's care
label when selecting spin speed.
Select the WASH TEMP to adjust the proper water
temperature for the wash cycle. Follow the fabric
manufacturer's care label when selecting wash
temperature.
Press START/PAUSE to start the wash cycle. Each
time the washer starts, a wake up routine is
initiated:
The door locks.
The wash basket brie fl y tumbles in both
directions.
The door unlocks.
The door locks.
The fi ll cycle begins.
Water Fill
The washer automatically fi lls before tumbling, and
maintains the proper fi ll level using a programmed
adaptive fi ll. The machine will not tumble while
fi lling.
Wash Water Temperature
The fi rst 10 seconds of fi ll is tap cold water only. If
needed, the control board will cycle the water valves
(water tempering) to achieve the target wash water
temperature selected. Water tempering only occurs
during the main wash cycle.
Tap Cold:
Cold water valve energized.
Tap cold never involves water tempering.
Water temperature determined by supply
temperature.
All fi lls except main wash are tap cold.
1.
2.
3.
4.
5.
•
•
•
•
(Continued Next Page)