Midea MFH180-G1302DS F01E-EU, Техническое обслуживание руководство

Страница: 53 / 62

Outer Tub Assembly and Suspension
The outer tub assembly is constructed in two halves
and contains the wash basket. The bearing and seal
assembly is part of the outer tub rear half. The outer
tub assembly is supported by 2 suspension springs
and 4 dampers. Each spring is located between the
top of the tub assembly and a cabinet top brace,
one on each side. Washer stabilization is achieved
by the use of 4 dampers that are located between
the bottom of the tub assembly and chassis, 2 per
side.
To remove the outer tub assembly:
WARNING:
The outer tub assembly is heavy and
requires two people to remove it from the washer
cabinet. Care should be taken when removing and
installing the outer tub assembly.
Drain the washer using the pump cleanout. (See
Pump
.)
Remove the top, control, service, and front
panels. (See
Top Panel, Control Panel, Service
Panel,
and
Front Panel
.)
Remove the dispenser. (See
Dispenser
. )
Remove the nozzle hose from the
Water Valve
:
Note:
The nozzle hose is diffi cult to remove.
a. Squeeze the clamp and slide it back.
b. Carefully break the nozzle hose loose by
inserting a small fl at-blade screwdriver
under the hose to break the seal.
c. Remove the hose.
1.
2.
3.
4.
Set the front bracket aside. 5.
Remove the tub vent hose from the left rear of
the outer tub:
Note:
The tub vent hose is diffi cult to remove.
a. Squeeze the clamp and slide it back.
b. Carefully break the tub vent hose loose
by inserting a small fl at-blade screwdriver
under the hose to break the seal.
c. Remove the hose.
6.
Remove the air pipe from the water level control.
Disconnect the heater assembly wires.
Remove the plastic wire tie that holds the heater
assembly wiring and the tub ground wire to the
outer tub.
Disconnect the motor wire harness, ground wire,
and the plastic wire tie that holds the wiring to
the motor.
Remove the tub drain hose from the pump.
Remove the 4 Phillips-head screws from the
cabinet rear cover.
Pull the cover outward from the middle.
7.
8.
9.
10.
11.
12.
13.
(Continued Next Page)
Tub Vent Hose
–
5 6
–
Water Valve