Midea MFH180-G1302DS F01E-EU, Техническое обслуживание руководство

Страница: 44 / 62

Motor Assembly
The motor assembly consists of a reversible,
variable speed, 3-phase induction DC motor, and
sensor. The motor drives the tub drive pulley with
a 7-rib belt. The sensor monitors motor rpm and
is connected to the control board. The motor
assembly is checked from the front of the washer
and removed from the rear.
Methods to Methods to check the motor assembly:
Remove the Rear Cover
Disconnect the motor wire harness.
On the motor plug, check for an approximate
resistance value of 5 ohms between any two of
the three wires:
Blue to white - 5
Ω
Blue to red - 5 Ω
White to red - 5 Ω
The sensor has a resistance value of
approximately 118 Ω between the two orange
wires.
Operation of the motor assembly can be checked
by using service test modes t10 . (See
Service Test
Mode
.)
Speci? c failures associated with the motor
assembly can initiate error codes E50, E52, E53, E55,
E56, E57, E58, E5B, E5C, E5D, E5E, E5F . (See Service
Test Mode .)
1.
2.
•
•
•
•
(Continued Next Page)
To remove the motor:
Remove the 4 Phillips-head screws from the
cabinet rear cover.
Pull the cover outward from the middle.
1.
2.
– 4 7 –