micro-trak MT-3405 LR F, Справочное руководство

Страница: 10 / 44

Installation
Mounting the Display Console
Select a mounting location which seems most workable, and
that best fits your needs. It should be con ve nient to reach
and high ly vis i ble to the op er a tor. DO NOT IN STALL IN A
PO SI TION THAT OB STRUCTS THE VIEW OF THE ROAD
OR WORK AREA. Whenever pos si ble, avoid lo ca tions that
expose the con sole to direct sun light, high tem per a ture,
strong chemicals or rain.
Place the mounting bracket in the selected lo ca tion, mark
holes, drill 1/4” (7mm) holes and mount bracket with bolts,
lock wash ers and nuts pro vid ed. (If bolts are not practical,
use self-tapping screws.) See Illustration 1.
Insert the console in the “U” bracket and install the console
knobs through the bracket, placing a rubber washer over
the threaded stud. Position console to proper viewing
angle and tighten the knobs securely.
Illustration 1
Hot
(White)
20-Amp In-line
Fuse Required
Ground
(Black)
+12 VDC
(RED)
+
Electrical Installation
The MT-3405 F must be connected to a 12-volt DC elec tri cal
system. Power is connected directly to the battery. The MT-3405
F has an ON/OFF switch on the console to turn the power off
when the system is not being used.
Locate the power cable harness and connect to the mating
connector on the console. Connect the blue chassis ground
wire to a good frame ground. See Il lus tra tion 2. Make sure
there is good metal-to-metal contact. Route the power cable
from the console to the battery. Cut off excess length. In
routing cable to battery, avoid ar eas where the ca ble may
be subjected to abra sion or ex ces sive heat. Install the in-line
fuse provided with the kit on the white wire, as illustrated,
to protect the circuit. Connect the WHITE wire (hot) to the
positive battery terminal. At tach the BLACK wire (ground) to
a screw or bolt on the equipment frame. See Il lus tra tion 2. Be
sure there is good metal-to-metal con tact.
Your MT-3405 F is equipped with an ad vanced elec tronic
mem o ry which does not re quire a con stant supply of pow-
er to re tain daily totals or calibration val ues. The advantage
with this type of memory is that it conserves battery power
and will not dis charge the vehicle’s battery when equipment
is not in use.
NOTE: For negative ground systems ONLY.
WIDTH BOOM
SELECT
TEST
SPEED
ADJUST
RATE
TARGET
RATE
CIRC
MIN
FLOW
FLOW
CAL
SPEED DISTANCE
FLOW
RATE
TOTAL AREA
APP. RATE TOTAL FLOW
SUB AREA
ON
OFF
1 2 3 4 5
B O O M S
RUN
HOL
AREA
HOUR
CAL
AUTO
MAN
RESET
MT-3405
™
F
AUTOMATIC RATE CONTROLLER
MANAUTO
CALHOLD
V 1 2 3 4 5
Illustration 2
Tools Needed to Install MT-3405F
•
Screwdrivers
•
Pliers
•
Set of Wrenches
•
Wire Cutter
•
Electric Drill and Bits
•
Hacksaw
•
12-Volt Test Light
•
Center Punch
•
Bench Vise
•
Hammer
10