MICRO-EPSILON 4350127.256, Руководство по эксплуатации

Страница: 21 / 173

Page 21
Installation and Commissioning Instructions
thicknessCONTROL MTS 8202.LLT / 4350127.256
4. Installation and Commissioning Instructions
4.1 Installation and Mounting
The installation site should preferably be free of contaminants such as dust or fumes.
These can result in measurement uncertainties. If needed, use the optional air purging
function on the sensors to reduce the accumulation of dust, etc. on the glass panes for
the laser and the receiver.
The installation site should be free of vibration.
The installation site must have adequate stability.
Install the measuring machine.
4.2 Undo Transport Lock
The measuring machine is supplied with a transport lock. Remove the transport lock
before initial operation
1
1 Transport lock
Fig. 22 Transport lock on the measuring machine
Undo the transport lock also on the base frame and the calibration component hold-
er of the measuring machine.
4.3 Back-up Fuse
Refer to the electrical plan for the rating of the back-up fuse for the measuring system ,
see 9.2 . The customer must use loop impedance measurement and appropriate cable
cross-sections to ensure prompt triggering of the back-up fuse.
CAUTION
Crushing or impact haz-
ard caused by displace-
ment of moving parts of
the measuring machine.
Release any transport
locks only after installa-
tion.
CAUTION
Loss of stability. Fasten
the measuring machine
sufficiently.