MICRO-EPSILON 4350006.71, Руководство по эксплуатации

Страница: 242 / 254

UBC10.241, UBC10.241-N1
U – Series
24V, 10A, DC-UPS
May. 2008 / Rev. 1.1 DS-UBC10.241-EN
All parameters are specified at an input voltage of 24V, 10A output load, 25°C ambient and after a 5 minutes run-in time
unless otherwise noted. It is assumed that the input power source can deliver a sufficient output current.
www.pulspower.com Phone +49 89 9278 0 Germany
12/23
14. F
RONT
S
IDE AND
U
SER
E
LEMENTS
Main unit shown below without battery compartment.
A Power Port
Quick-connect spring-clamp terminals, connection for input voltage and
output voltage.
B Signal Port
Plug connector with screw terminals, inserted from the bottom.
Connections for the Ready, Buffering, Replace Battery relay contacts and
for the Inhibit input. See details in chapter 13.
C Green Status LED
Ready:
Battery is charged > 85%, no wiring failures are recognized, input
voltage is sufficient and inhibit signal is not active.
Charging: Battery is charging and the battery capacity is below 85%.
Buffering: Unit is in buffer mode.
Flashing pattern of the green status LED:
Ready
Charging
Buffering
ON
OFF
ON
OFF
ON
OFF
D Yellow Diagnosis LED
Overload:
Output has switched off due to long overload in buffer mode
or due to high temperatures.
Replace battery: Indicates a battery which failed the battery quality test
(SoH test). Battery should be replaced as soon as possible.
Buffer-time expired: Output has switched off due to settings of Buffer-
timer Limiter. This signal will be displayed for 15 minutes.
Inhibit active: Indicates that buffering is disabled due to an active inhibit
signal.
Flashing pattern of the yellow diagnostic LED:
Overload
Replace
Battery
Buffer time
expired
Inhibit
active
ON
OFF
ON
OFF
ON
OFF
ON
OFF
E Red Check Wiring LED
This LED indicates a failure in the installation (e.g. too low input voltage), wiring, battery or battery fuse.
F Buffer-time Limiter:
User accessible dial which limits the maximum buffer time in a buffer event to save battery energy. When the
battery begins to recharge after a discharging event, the process is completed much faster since only the energy
which was taken out of the battery needs to be “refilled”. The following times can be selected: 10 seconds, 30
seconds, 1 minute, 3 minutes, 10 minutes or infinity (until battery is discharged) which allows buffering until the
deep discharge protection stops buffering.