MH RYZ 50 Cross C, Руководство по обслуживанию

Страница: 42 / 92

RYZ
Unscrew the side securing bolts on the engine support.
Remove the engine securing bolt (1) and push the support
forwards.
N.B.:
To remove the cylinder head, the cylinder and the piston,
see corresponding chapter in this section.
REMOVAL
Remove the seat – see “Removing the seat” in Section
4 “CHASSIS”.
Remove the fuel tank – see “Removing the fuel tank” in Section
4 “CHASSIS”.
Remove the left-hand side fairing.
Disconnect the battery.
Drain the cooling circuit (drain screw [1] on the water pump).
Remove the chain guard (two bolts).
Remove the chain.
Remove the exhaust – see “Removing the exhaust” in Section
4 “CHASSIS”.
Disconnect the oil supply and the oil pump control cable.
Remove the clutch cable.
Disconnect the starter motor, the neutral switch, the magneto
output wiring (the yellow cable and high-tension coil supply ca-
bles), the suppressor and the temperature sensor.
Disconnect the carburettor heating pipes.
Separate the carburettor from the air fi lter box and inlet con-
nectors.
Disconnect the coolant pipes on the water pump and cylinder
head.
8)
9)
1)
2)
3)
4)
5)
6)
7)
8)
9)
10)
11)
12)
13)
14)
5-4 ENGINE
ENGINE ASSEMBLY
5