MH RYZ 50 Cross C, Руководство по обслуживанию

Страница: 64 / 92

RYZ
ADJUSTING THE CLUTCH CONTROL LEVER
Loosen the pressure plate locknut (1).
Position the lever resting on the control rod.
Turn the central pressure plate bolt (2) to position the control
lever at 30° with respect to the sealing joint of the magneto
cover.
Tighten the locknut without altering the adjustment.
Nut tightness torque:
2.7 daN•m (27 N•m)
FITTING THE KICK-START SYSTEM (WHERE FIT-
TED) AND THE CLUTCH COVER
Fit the spring (1) onto the kick-start shaft.
Fit the kick-start attack gear (2), and the take-off ramp (a)in
alignment with the arm of the return spring (b).
Fit the kick-start shaft (3).
Fit the two centring rods and a new paper gasket.
Fit the clutch cover, turning the crankshaft-connecting rod ma-
nually if necessary, so that the water pump gear meshes with
the crankshaft-connecting rod gear.
Fit the eight cover securing bolts.
Bolts tightness torque:
1.1 daN•m (11 N•m)
Fit and apply the kick-start lever slightly and hold it in position.
Fit the starter shaft stop.
Nut tightness torque:
3 daN•m (30 N•m)
Release the kick-start lever.
FITTING THE MAGNETO
Fit the armature assembly.
Fit and tighten the three securing bolts (1) on the armature as-
sembly.
Bolts tightness torque:
0.3 daN•m (3 N•m)
1)
2)
3)
4)
1)
2)
3)
4)
5)
6)
7)
8)
9)
1)
2)
5-26 ENGINE
5