48 / 72
HBC-series V7 LV+MV
P71:
BB data logging period
(Internal BlackBox record period)
/ real time Monitoring
The standard write speed is 100 ms. With this rhythms are stored in the memory averaged measured values. Recording time is about 12 minutes.
If you want to write faster (each 10 ms), averaging is faster (fewer samples), rapid of the details are better drawn, but recording time is 10 times
shorter. You can select a record from the beginning or end (last 12 minutes).
You can also data record into the BB off and on "Monitoring", i.e., displaying data in real time on the PC screen via module USBCOM 4(i).
10 ms
record from start
100 ms
record from start
100 ms from end
record of last
12
minutes
BlackBox off, Monitoring in real time enabled
To internal BlackBox (data logger) are saved different data, for details see chapter “
P85:
Parameters saved to the BlackBox, sets+
DC/DC converter values (if available)
DATA (AUX 1)
As the number of values stored into the internal BlackBox is limited, you can choose (select) some measured values to be stored (at the expense
of others). Which it will, this parameter specifies. Stored values are defined here: "
The data stored in the record ....
“
P28:
Motor temperature sensor
Available for sensor motors only.
off
Si diode
10k NTC (by EFRA recommendation)
KTY81-210
KTY84-151
When sensor is not connected, set “off “.
P29:
Battery temperature sensor
If your controller may measure battery temperature (only OPTO versions), is possible set sensor type:
off
Si diode
10k NTC
KTY81-210
KTY84-151
When sensor is not connected, set “off “
P30:
Controller temperature limit
(value in °C)
If for any reason you need to reduce the maximum temperature limit of the controller, enter demand value to this parameter.
P31:
Motor temperature limit
(value in °C)
If your controller may measure motor temperature (only sensor motor types, marked SE) and you have connect some of defined sensors, you can
set temperature value for which is motor switch-off.
P32:
Battery temperature limit
(value in °C)
If your controller may measure battery temperature and you have connect some of defined sensors, you can set temperature value for which is
motor switch-off.
P37:
Calibration of the motor temperature sensor
(value in °C)
For easy replacement of the temperature sensor you can make its calibration at any time. If you specify this parameter in the current ambient
temperature in which the sensor is calibrated (of course after stabilization of temperature), write them into the controller and turn-off and back
turn-on the controller. If everything went correctly, the controller after this normally works and you can normally run, drive, etc. with calibrated
temperature sensor. In case some problem occurs, the situation is indicates on the LEDs.
Can be combined with other parameter settings, i.e. including the present motor temperature sensor calibration can be calibrated the battery tem-
perature sensor, see parameter P36.
Caution - for each memory bank be made separately (possible advantage of different sensors for different settings).
Time
(minutes)
19
Start
of the record:
Joystick moving (control signal)
from the STOP position
after controller is
turned-on
10 ms
100 ms
100 ms from end (last 12 minutes)
0
1,2
12
6
Overall running time the controller
Record
Stop
:
(controller turned-off)
18
