9 / 72
HBC-series V7 LV+MV
Mounting:
Mounting of controllers is possible using either the 4 mounting holes in the corner of the main PCB or "on the edge" using two M3
screws in the cooler (red arrows) from both sides (M3 screws are needed).
If you use the holes in the main PCB, use spacer plate from non-conducting material (polyamide, xxxx etc). Choose the M3 screw head
such that it is not in contact with the surrounding copper areas on the b
oard (that is up to Ø 6mm) or use an insulating pad.
If you use holes in the cooler, it does not matter which material is used as the coolers are insulated, they are not connected to any po-
tential.
If the system in which the controller is mounted vibrates, fasten it using suitable silent blocks.
HBC-series TMM 18063 V7, TMM 100120 V7,
side view on cooler without fan
(default dimensions)
HBC-series TMM 25063 V7, TMM 140120 V7,
view from side of cooler with fans
(default dimensions)
96 mm
63
m
m
17.15
73.15
3.05
56
.9
0
4 × mounting hole
3.5 mm
for M3 screws
60
40
100 mm
10
0
mm
3.94
92.20
92
.9
6
3.56
4 × mounting hole
3.5 mm
for M3 screws
63
40
4 × mounting hole with M3 thread
4 × mounting hole with M3 thread
