MGM 100120-3, Руководство по эксплуатации

Страница: 15 / 72

15 / 72 HBC-series V7 LV+MV
Connector K15 (auxiliary driving / communication port):
RS 232 TTL can be also optically coupled

Pin 1 : RX / rotation direction / INP_4 (or +optocoupler input)

Pin 2: GND

Pin 3: TX / OUT_4 (or +optocoupler output)

Pin 4: +5V external feed, if inner feeding is not used., common also for K16 ( or
“– optocoupler output”)
Connector K16 (CAN or RS 485 bus / general I/O ):
CAN /
RS 485 can be also optically coupled

Pin 1 : CAN_L / line B for RS 485 / OUT_3

Pin 2: CAN_H / line A for RS 485 / INP_3

Pin 3: GND
Connector K17, K18 (ICS-2):
communication with PC (module USBCOM 4), outer I2C bus, indication, ….
K17 K18

Pin 1 : 5V
●
Pin 1 : BL-1 signal

Pin 2: GND ● Pin 2: SDA

Pin 3: 3.3V ● Pin 3: SCL

Pin 4: SCL ● Pin 4: 3.3V

Pin 5: SDA ● Pin 5: GND

Pin 6: BL-1 signal ● Pin 6: 5V
Connector K19 (current probe)
– only for external FET / IGBT modules
:

Pin 1 : GND

Pin 2: SENSE +, input from current probe HALL 400 B / 600B (or compatible type)

Pin 3: +10V output, feeding for current probe HALL 400 B / 600B
Connector K20 (emergency disconnection):

Pin 1 : PWROFF_INP,
input of signal “disconnect battery” (
or +optocoupler input)

Pin 2: -OPT_INP (
–optocoupler input)

Pin 3: PWROFF_OUT,
output „switch-off“ (
or +optocoupler output)

Pin 4: GND / -OPT_OUT (
–optocoupler output )
Connector K21 (braking resistors driving):

Pin 1 : driving output for switching component (MOSFET) which switch-on braking resistors, value +3.3V or +10V

Pin 2: GND
Jumper J1:
connection of terminating impedance of CAN or RS 485 bus.
(coupler or soldered jumper)

Closed pins = termination impedance for CAN or RS 485 connected

Open pins = termination impedance for CAN or RS 485 disconnected