MG Gloster, Руководство пользователя, Страница: 223 / 264

214 215
MAINTENANCE AND SERVICE
Washer Nozzles
Adjust and Clean
Front Washer Nozzle
Front washer nozzle is not adjustable.
Make sure that the washer reservoir contains washer fluid before
cleaning the nozzle. If the nozzle is blocked, carefully clean it with a fine
line or needle.
Rear Washer Nozzle
Rear washer nozzle is not adjustable.
Wiper Blade
Check
Check the edge of wiper blades for roughness or damage, and check if
the blade rubber is secure from top to bottom.
Note: If there are grease or other impurities on the rubber blades, it
may cause the wiper work improperly and may damage the
windshield.
MAINTENANCE AND SERVICE
Replacement
Removal
- Lift the wiper arm from the windshield to make an angle of about 15
degrees between the blade and the arm.
- Push the retaining clip (in the direction of the arrow), slide the blade
bracket along the direction of the arrow to the arm so as to loosen
the pivot of the bracket from the hook of the arm.
Note: Remember the relative location of hook and bracket
because the replacement blade is required to be fitted later in the
same way.
Installation
- Install the blade holder on the hook.
- Snap the pivot into the hook and push it in place, until hearing an
audible sound of snapping into place.
Maintenance
Wash it with high-quality or neutral detergent, and wipe with a lint-free
dry soft cloth.
Seat Belt
Check
The seatbelt is equipped with a sensitive retractor,
which will be locked only in hard acceleration,
deceleration or drastically bend.
Don't test the locking device by fiercely and intentionally
bending your upper body forward.
Check all the seat belts as shown below:
• Check all the seat belt anchor point for safety.
• Insert the locking tab into the buckle and check if the locking action is
definite. Push the red button and check if the locking tab pops neatly.
• With the belt partially loose, hold the locking tab and pull it suddenly.
Check if the safety device can be locked automatically and prevent
further looseness.