MG Gloster, Руководство пользователя, Страница: 202 / 264

194 195
EMERGENCY TROUBLESHOOTING
1 Make two vehicle and battery jumper close enough.
2 Shut down the engine and turn off all electrical equipment.
3 Connect the positive ter) of both batteries with a red
jumper cable.
4 Connect a black jumper cable between the negative terminal (-) of
power supply battery and the grounding point (not negative
terminal) of the battery to be charged.
5 Make sure all connecting devices contact well.
6 Check whether jumper cables contact with any moving parts when
engine starts.
7 Check whether the parking brake handles of vehicle has been
engaged and whether the shift lever is in N gear.
• Before disconnecting the battery, be sure to shut down the engine
and turn off all electrical appliances for more than
2 minutes. Please avoid the terminals from contacting with metal
components of the body during disconnection. The resulted short
circuit may generate electric sparks.
• Reverse connection of positive and negative cables will cause
damage to electrical system.
Jump Start
It is never allowed to start the vehicle by pushing or
towing.
Make sure that both batteries are of the same rated
voltage (12V), and the jumper cables are approved for
use with 12V car batteries.
EMERGENCY TROUBLESHOOTING
Starting
Start the vehicle with power supply battery and allow it idle for several
minutes.
1 Start the vehicle with battery to be charged.
2 Allow the engine idle for 2 minutes and above after it is started.
3. Once the car is started drive for more than 100 kms. to make sure
battery gets some charge. (It does not guarantee further discharge)
Note: If it fails to start after several attempts, the vehicle probably
needs service.
Disconnection
1 Shut down the engine of the donor vehicle.
2 Make sure the wire terminals will not contact with each other and
will not contact any moving parts of engine during disconnection.
3 Remove the jumper cables. Removal is the reverse of connection.
Fuse Replacement
Fuses of this vehicle are respectively placed in two boxes.
Any electrical components of the vehicle will be damaged after being
splashed with fluid. Be sure to cover any electrical components. The
contents in the fuse specification list are subject to continuous
modification according to vehicle configuration and technical state.
Please follow the list based on actual condition of your vehicle.
Driver Compartment Fuse Box
Driver compartment fuse box is located behind the lower storage box at
driver side.