MG Gloster, Руководство пользователя, Страница: 158 / 264

150 151
STARTING AND DRIVING
Resume Set Speed
If you have set the cruise speed of constant speed cruise control system,
the cruise control function will be disabled when you depress the brake
pedal or press , but this set speed in the memory will not be cleared.
To resume the pre-set speed, press RES+ button when the vehicle
speed reaches 40km/h or above, and then the vehicle speed will be
resumed to the pre-set value.
Accelerate with the Cruise Control System Enabled
There are two method to accelerate:
• Accelerate by depressing the accelerator pedal.
• If the constant speed cruise control system has been enabled, press
RES+ button and hold it until the vehicle accelerates to the desired
speed, and then release it. To accelerate by minor increment, press
RES+ button, and then release it. Every time this operation is done, the
Decelerate with the Cruise Control System Enabled
If the constant speed cruise control system has been enabled:
• Press SET- button and hold it until the vehicle decelerates to the
desired speed, and then release it.
• To decelerate by minor increment, press SET- button and then
release it. Every time this operation is done, the vehicle will slow
down by about 1km/h.
Overtaking with the Cruise Control System Enabled
Speed up with the accelerator pedal. When you release the accelerator
pedal, the vehicle will decelerate to the pre-set cruise control speed.
Applying Cruise Control on a Ramp
The performance of the constant speed cruise control system on a ramp
depends on vehicle speed, load and gradient of the ramp. When the
vehicle runs uphill, it may be required to depress the accelerator pedal
to maintain the vehicle speed. When the vehicle runs downhill, it may be
required to brake or shift to a low gear to maintain the vehicle speed.
The cruise control function will be disabled when the brake is enabled.
STARTING AND DRIVING
Terminate the Cruise Control
There are three ways to disable the cruise control:
• Slightly depress the brake pedal once; the
ｷ
constant Speed Cruise
Indicator Lamp" on the instrument cluster will change from green to
white when the cruise control is disabled.
• Press
• Press to tum off the constant speed cruise control system
completely. The cruise control speed will not be resumed.
Clear Speed Memory
The cruise control set speed memory will be cleared when you press
or turn off the ignition switch.
Parking Assist System
Note: The type of parking assist system equipped on your vehicle is
subject to the actual vehicle configuration purchased.
Reverse Radar Sensors
The parking assist system is not always reliable. It only
plays the guiding role! Reverse radar sensors may be
unable to detect certain types of barriers, such as fine
objects like wire entanglement or rope, small objects
close to the ground, tapered objects and some objects
with unreflecting surfaces.
Reverse radar sensors shall be free of dirts, ice and snow.
Deposits on the surface of a reverse radar sensor will
hinder the sensor's normal operation. Avoid spraying
reverse radar sensors directly with high-pressure washer
at a close range when washing the vehicle.
Four reverse radar sensors in the rear bumper scan the area behind the
vehicle and judge whether there is any barrier. If detecting any barrier,
the sensor will compute the distance between the barrier and vehicle
rear end and remind the driver of the barrier through alarm sound
signals. It is important to know that this system is a parking assist system
only and cannot be regarded as a replacement for observation and
personal judgment.