MG Gloster, Руководство пользователя, Страница: 168 / 264

160 161
STARTING AND DRIVING
If the window before any camera unit of the windshield
is cracked, scratched or damaged by stone impact, and
the affected area is about 0.5x3.0mm or greater, then
contact our Service Dealer for the windshield
replacement and service. Failure to take any action
may degrade the performance of the driver assist
system using the camera unit. To avoid operation
failure, insufficient or delayed operation of the driver
assist system using the camera unit, please also follow
the suggestions below:
- We recommend you replace the whole windshield
instead of repairing the crack, scratch or damage by
stone impact on the area before the camera unit.
- Before windshield replacement, please contact our
Service Dealer to ensure you select and Install an
appropriate windshield.
- When replacing the windshield wiper, Install the
wiper of the same type or one approved by the
Company.
- After windshield replacement, seek our Service
Dealer to recalibrate the camera unit and ensure
proper operation of the system functions based on
the camera.
• Limited view
The camera unit has a limited view. In some cases, the camera cannot
detect another vehicle, or the detection starts later than expected.
- On the curves, the ACC may respond to the vehicle in another
lane, or it may not have time to respond to the vehicle in the same
lane. In this case, the vehicle may collide with the front vehicle or
be out of control. Particular care shall be taken for curves, and
apply the brake when necessary. For driving on the curve, select
an appropriate speed.
- When the vehicle from the adjacent lane drives ahead of your
vehicle, if it is not within the detection range of the sensor, it
cannot be detected by the sensor, this will delay the reaction of
the ACC. The driver shall pay close attention to the action of the
vehicle in the adjacent lane, and take active intervention when
necessary.
STARTING AND DRIVING
- Do not use the ACC on steep ramps. The ACC cannot detect any
vehicle In the same lane on steep ramps. Normally, the driver shall
control the acceleration and brake by himself on steep ramps. If the
brake Is applied, the ACC will be disabled. In addition, inaccurate
speed control may occur when the adaptive cruise is applied on a
sloped road.
- The ACC cannot determine the accurate width of the front lane, so
when the front lane is narrow, and the driver thinks that the vehicle
cannot pass through it, the driver shall disable the ACC by brake
intervention immediately and control the vehicle by himself.
- The ACC cannot detect all kinds of vehicles on the road, especially
for narrow vehicles, such as bicycle, motorbike, etc. The driver shall
pay close attention to the narrow vehicle before the vehicle.