MG Gloster, Руководство пользователя, Страница: 166 / 264

158 159
STARTING AND DRIVING
Precautions for Semi-Automatic Parking
• Before parking, please make sure there are no obstacles in the
parking space, such as Stones, thin pillars, tow bars or bicycles etc, as
the system may not be able to detect such obstacles.
• When parking the vehicle in a parking place adjacent to the edge of
the road with the intelligent semi-automatic parking assist system,
the running track set by the system may go beyond the edge of the
road, which results in damage to the tires or rims of the vehicle by
protruding road shoulder, so pay attention to the surrounding
environment, control the speed, and make manual intervention if
necessary.
• Do not clean the sensor with a high pressure cleaner or a steam
cleaner to avoid sensor damage. In a vehicle wash, rinse the sensor
surface with a small water flow in a short time, and keep a distance of
at least 10cm above.
Driver Assist System
Note: The type of driver assist system on your vehicle depends on
the actual configuration of your vehicle.
This vehicle is equipped with the multiple functions of the driver assist
system, which can provide the following functions of the active driver
assist system:
• Adaptive Cruise Control (ACC)
• Forward Collision Warning (FCW)
• Autonomous Emergency Braking (AEB)
• Lane Departure Warning (LOW)
• Blind Spot Detection (BSD)
• Parking Assist System
Camera of Drive Assist System
The camera of the drive assist system is used to realize the following
functions:
• Adaptive Cruise Control (ACC)
• Forward Collision Warning (FCW)
• Autonomous Emergency Braking (AEB)
• Lane Departure Warning (LDW)
STARTING AND DRIVING
The windshield before the
camera unit has dirt or ice/snow.
The view of the camera is
blocked by fog, heavy rain or
snow.
Dirt may occur between the
inside windshield and the camera
unit.
Direct sunlight and strong
oncoming light or severe road
reflection.
Damaged camera unit hardware.
Restrictions for Cameras
There are some restrictions for the camera unit, which limit the function
of the unit.
• Limited view
Like human eyes, the view of the camera is also
limited, i.e. the camera will have poor sight in storm,
blizzard, fog, severe dust storm or snowy weather,
etc. In these situations, reliance on the function of the
camera system may be reduced or released
temporarily.
When using it to scan the lane, the strong oncoming
light, reflection from the lane, ice and snow on the
road, dirty or unclear lane line, etc may greatly
degrade the function of the camera.
Do not place, post or install any article on the
outside/inside windshield before or around the
camera unit, this may interfere with the related
The camera unit is located at the upper side of the windshield, if the
information center of the instrument cluster displays "Please Clean
Windshield", "Camera System Failure", then the camera unit cannot
detect other vehicles in front of the vehicle. The table below shows
the example of the possible cause for the related fault displayed and
Remove the dust, ice or snow on
the windshield before the camera
unit.
No remedy available.
Sometimes, the recognition
function of the camera unit is
degraded in heavy rain or snow.
We suggest you drive to our
Service Dealer for cleaning of the
windshield in the unit cover.
No remedy available. Sometimes,
the recognition function of the
camera is degraded in strong
direct sunlight.
We suggest you drive to our
Service Dealer for service.
• Damaged windshield
Cause Action