
8
9
BEFORE YOU DRIVE
Keys
1 Remote key with PEPS
Note: If a key is lost, you must provide the key number on the metal
or plastic plate attached with the key, and our Service Dealer will
provide the replacement. To ensure safety, you are recommended
to keep the metal or plastic plate attached with key properly.
Note: For the sake of safety, the key has been electronically coded
with the engine immobilizer system and can be used with the
system in the matching way only. Special procedures shall be
followed to manufacture a same key with the lost one. Any
The vehicle is equipped with 2 remote keys with passive entry & passive
start system (hereinafter referred to as PEPS).
Remote Key
Remote key is a control component of automobile central locking
Note: The remote key/keys have been electronically coded with
the locking/unlocking system and can be used with the system in
the matching way only. Special procedures shall be followed to
manufacture a same remote key with the lost one. All Service
Dealer are ready to provide assistance for you. Please refer to
“Central Locking System” in this section for more details about the
remote key.
The engine immobilizer system can accept 4 coded keys at most (for
remote keys with PEPS function).
Caution
BEFORE YOU DRIVE
Extension/Retraction of Mechanical Key Portion
Mechanical Key Portion of Remote Key can be extended or retracted,
hereinafter referred to as mechanical key portion.
Mechanical Key Portion of a Remote Key with PEPS
Press the release button on the remote key with PEPS, remove the rear
trim panel and pull the mechanical key portion from the ey body.
k
To retract the mechanical key portion, directly insert it into the ody of
b
remote key with PEPS and close the rear trim panel.
Replace Battery in Remote Key
Key battery has the risks of fire, explosion and
combustion. Do not charge the battery. The used
battery shall be disposed In a proper way. Keep the
battery in the place out of reach by children.
To replace the battery, operate as per the following steps:
Remote key with PEPS battery replacement
1 Release the button on the remote key with PEPS.
2 Remove the key head from the key itself.
3 Pry the upper and lower panels of the main body, remove the PCB
(with battery) from the lower panel.
Caution
Caution
4 Withdraw the old battery and fit the new battery. (Same
specification)
Never use a metal tool to pry the PCB.
It is essential that the correct battery polarization is observed.
5 Put the plastic support with battery into the lower panel of the main
body, and install the PCB subsequently.
6 Refit the upper and lower panels of the main body.
Содержание Gloster
