Meyer LPV 3, Руководство пользователя

Страница: 62 / 72

62
63
Post Season Maintenance
At the end of the winter season, perform
the post-season maintenance as listed
in the maintenance service schedule to
prevent costly repairs at the start of the
ne t season. Also don t forget to
1. Empty and thoroughly wash entire
spreader with warm soap and water.
2. Spreader may be treated with any
commercial salt neutralizer.
3. Lubricate drag chain, roller chains,
and bearings.
4. Remove, clean, and store electric
clutch.
5. Oil or paint any rusty parts or surfaces.
Maintenance
Maintenance Service Schedule
MAINTENANCE TASK TO BE COMPLETED
Pre-Season Daily
10 Hours
or Weekly
40 Hours
or Monthly Post-Season
Inspect spreader for loose, missing, or damaged parts or hardware X X X
Verify spreader is securely attached to vehicle X X
Inspect electrical connections and apply dielectric grease to connections X X X
Ad ust drag chain tension chain wiper position X X
Check gearbox oil level X X
Inspect & clean gearbox breather X X
Grease gearbox input shaft bearing X X X
Flush and re ll gearbo oil X
Lubricate drag chain X X X
Ad ust v-belt roller chain tension X X
Lubricate roller chain X X X
Grease idler, drive shaft, and spinner shaft bearings X X X
Oil or paint rusty surfaces X X
Replace wireless remote transmitter battery X
Clutch maintenance X X
Check Hydraulic Fluid evel X X
Replace hydraulic filter X X
Flush and re ll hydraulic reservoir X
Engine Maintenance As required per engine manufacturer
General Troubleshooting
Condition Possible Cause Correction
Conveyor will not
operate
Hydraulic system not operating properly See hydraulic troubleshooting
Variable speed controller not functioning properly See variable speed controller troubleshooting
Wireless controller not functioning properly See wireless controller troubleshooting
Electric clutch not engaged Engage clutch
Conveyor jammed by a foreign object, or frozen material Inspect conveyor for obstruction and remove
Damaged gearbox Inspect and repair gearbox
Electric clutch not operating properly See electric clutch troubleshooting
Loose or damaged v-belt or roller chain Ad ust or replace v-belt or roller chain
Loose or damaged drag chain Ad ust or replace drag chain
Worn drive sprockets Replace drive sprockets
Shaft keys missing from sprockets or gearbox Inspect for missing keys and replace
Conveyor operates
erratically
Shaft keys missing from sprockets or gearbox Inspect for missing keys and replace
Hydraulic system not operating properly Refer to hydraulic system troubleshooting chart
Loose or damaged v-belt Ad ust or replace v-belt
Electric clutch not operating properly See electric clutch troubleshooting
Loose or damaged drag chain Ad ust or replace drag
Worn drive sprockets Replace drive sprockets
Troubleshooting Guide