Meyer LPV 3, Руководство пользователя

Страница: 35 / 72

34
35
LPV Installation / Assembly Instructions
Supplied hardware to be
installed in six locations
SPINNER
INSTALLATION
Engine Driven LPV Spreaders
1.
Connect spreader power and ground wires to the appropriate
power and ground wires installed on vehicle.
2. Caution: Spreader may be shipped without engine oil,
refer to engine manufacturer’s instructions.
3. Caution: Spreader may be shipped without oil in the gear
bo . Fill gearbo to oil level plug with an W
gear type lubricant.
4. Add fuel to engine fuel tank, refer to engine manufacturer s
instructions.
5. Test run spreader.
Electric LPV Spreaders
1.
Connect spreader wire harnesses to appropriate
harnesses installed on vehicle.
2. Caution: Spreader may be shipped without oil in the gear
bo . Fill gearbo to oil level plug with an W
gear type lubricant.
3. Test run spreader.
LPV Installation / Assembly Instructions
Spinner Assembly Installation
Spinner should be solidly supported during installation.
Spinner assembly weighs over lbs. ( . kg) and may
require more than one person for safe installation.
1. Raise engine/motor shroud.
2. Slide spinner assembly into the spreader discharge.
Flanges on spinner frame should be resting on the top of
flange on longitudinals.
3. Bolt spinner assembly to spreader in four places using
provided hardware.
4. Ensure lower sprocket on gearbox input shaft and spinner
shaft sprocket are aligned, install roller chain between the
two sprockets.
5. Connect ends of roller chain with supplied master link.
6. Ad ust roller chain tension by loosening four spinner shaft
mounting bolts and sliding spinner shaft away from the
gearbo (towards passenger side of vehicle).
7. Make sure spinner shaft is aligned straight up and down
before tightening spinner shaft mounting bolts.