Meyer LPV 3, Руководство пользователя

Страница: 33 / 72

32
33
LPV Installation / Assembly Instructions
Lifting Location
(Crane only)
Tiedown Location
(each corner)
Bolt Location
(each body jack)
LIFTING & TIEDOWN
LOCATIONS
Vehicle Preparation
1.
Turn off vehicle engine, set parking brake, and remove keys.
2. Remove tailgate from vehicle.
3. Remove trailer hitch if equipped.
Spreader Preparation
1.
Remove all loose items from inside of hopper such
as the spinner assembly, controller, etc.
2. Top screen may be removed for access to internal lift point.
3. Make sure hopper is completely empty before attempting
to lift or move spreader.
Lifting Spreader
All chains, hooks, and straps must be of an ade uate weight
rating to support entire spreader including any additional or
optional e uipment that may be installed. Never attempt to lift
or move a spreader with material in the hopper.
1. Center Mounted ift Hook series spreaders can be
lifted with a crane or hoist by utilizing the hole on the lift
channel located on the inside of the spreader hopper.
Spreader Installation
The LPV series spreader should be mounted directly on vehicle
bed, spreader is not designed to be supported by body jacks
alone or for chassis mount applications. Shipping skid is intended
to be removed before mounting spreader. Verify mounting
method is acceptable to vehicle manufacturer before attempting
to mount spreader.
1.
Place spreader directly onto bed of vehicle with discharge
at the rear of the vehicle.
2. Spreader is designed sit directly on vehicle bed. Do not
support spreader by body jacks alone. Spreader is not
designed to be chassis mounted.
3. Attach spinner assembly to spreader. Make sure spreader
cannot tip when spinner assembly is installed (see spinner
assembly installation instructions).
4. Reposition spreader on vehicle bed, just short of the spinner
assembly making contact with the rear most part of the
bed, bumper, pintle hook, etc.
5. olt spreader to the vehicle using a minimum of four grade
5 bolts and corresponding washers and lock nuts installed
through the mounting hole located in each body jack.
6. Install one ratchet strap from each corner of vehicle bed
to appropriate spreader tie down location. Straps should
be installed at opposing angles to prevent spreader from
sliding in vehicle bed.
LPV Installation / Assembly Instructions
The LPV series spreader can be mounted and stored as a single unit. The LPV series spreader will mount on most
light and medium duty pickup trucks or utility vehicles.