Meyer LPV 3, Руководство пользователя

Страница: 38 / 72

38
39
PV Installation / Assembly Instructions
Spinner Assembly Installation
Spinner should be solidly supported during installation. Spinner
assembly weighs over lbs. ( . kg) and may re uire more
than one person for safe installation.
1. Raise engine/motor shroud.
2. Slide spinner assembly into the spreader discharge.
Flanges on spinner frame should be resting on the top of
flange on longitudinals.
3. Bolt spinner assembly to spreader in six places using
provided hardware.
4. Ensure lower sprocket on gearbox input shaft and spinner
shaft sprocket are aligned, install roller chain between the
two sprockets.
5. Connect ends of roller chain with supplied master link.
6. Ad ust roller chain tension by loosening four spinner shaft
mounting bolts and sliding spinner shaft away from the
gearbo (towards passenger side of vehicle).
7. Make sure spinner shaft is aligned straight up and down
before tightening spinner shaft mounting bolts.
Engine Driven PV Spreaders
1.
Install battery onto spreader and secure with provided battery
hold down hardware. An automotive type battery with a
minimum of CCA is recommended.
2. Caution: Spreader may be shipped without engine oil,
refer to engine manufacturer’s instructions.
3.
Caution:
Spreader may be shipped without oil in the gear
bo . Fill gearbo to oil level plug with an W
gear type lubricant.
4. Add fuel to engine fuel tank, refer to engine manufacturer s
instructions.
5. Test run spreader.
Electric PV Spreaders
1.
Connect spreader wire harnesses to appropriate
harnesses installed on vehicle.
2. Caution: Spreader may be shipped without oil in the gear
bo . Fill gearbo to oil level plug with an W
gear type lubricant.
3. Test run spreader.
Hydraulic PV Spreaders
Conveyor and spinner motors may be connected in series or
parallel. Hoses may be reversed to obtain proper rotation. All
controls, hoses, and couplers must conform to industry standard
speci cations and N .
1. Connect hydraulic hoses from vehicle to spreader
conveyor and spinner motors.
2. Check vehicle hydraulic reservoir for proper fluid level.
3. Caution: Spreader may be shipped without oil in the
gearbo . Fill gearbo to oil level plug with an W
gear type lubricant.
4. Test run spreader.
5. Recheck vehicle hydraulic reservoir for proper fluid level.
Control and hydraulic system specifications
Hydraulic oil: ood grade of MS W oil with wear, o idation,
and foam inhibitors
Oil Filter: Micron element return line lter
Relief Valve Setting: SI Ma imum
Oil Flow (single flow controller): - M
Oil Flow (dual flow controller): - M spinner / - M
conveyor
PV Installation / Assembly Instructions
Supplied hardware to be
installed in six locations
SPINNER
INSTALLATION
FPO