6
There are other
thru axle systems
which are
a
combination
of threaded axle and quick-
release system.
After this, close both quick-release levers
to clamp the axle. Proceed as with regular
quick-releases. From the start of the closing
movement up to about the first half of its trav-
el, the lever should move very easily without
clamping the wheel, whereas over the second
half of its travel the force you need to move
it should increase considerably. Towards the
end of its travel the lever should be very hard
to move. Use a matching Allen key to adjust
the initial tension of the quick-release lever.
Use the palm of your hand while your fingers
pull on an immovable part, such as the fork
leg.
7. How to use the quick-releases
With these systems, the wheel including
brake disc, must be mounted in fork and
brake calliper. Then, the thru axle must be
slided through the drop-out of one fork leg
into the thread of the second fork leg where
it is screwed in. The fold-out screw-in fitting
helps you in doing so.
Do not use any other tools to fix the
axle. A too tight fixing of the axle can
damage the axle or the fork leg.
In any case make yourself familiar
with the user manual of the according
fork manufacturer.
