Mercedes-Benz G-Class 2016, Руководство пользователя

Страница: 120 / 261

Always replace all brake discs and brake pads/
linings on an axle at the same time. Always fit
new brake pads/linings when replacing brake
discs.
The vehicle is equipped with lightweight brake
discs to which the wheel assembly with rim and
threaded connection is matched.
The use of brake discs other than those
approved by Mercedes-Benz may alter track
width and is subject to approval, if applicable.
When handling the brake discs, shock-type
loads such as those experienced when changing
wheels, can lead to a reduction in comfort when
driving with lightweight brake discs. Avoid
shock-type loads on the lightweight brake discs,
particularly on the brake plate.
Driving on slippery surfaces
!
Where possible, avoid spinning the drive
wheels when pulling away on slippery roads.
You could otherwise damage the drive train.
This type of damage is not covered by the
terms of the Mercedes-Benz warranty.
X
Engage the differential locks if necessary
(
Y
page 126).
Driving on wet roads
Aquaplaning
If water has accumulated to a certain depth on
the road surface, there is a danger of aquaplan-
ing occurring, even if:
R
you are driving at low speeds
R
the tyres have adequate tread depth
For this reason, drive in the following manner in
the event of heavy rain or in conditions in which
aquaplaning can occur:
R
lower your speed
R
avoid tyre ruts
R
avoid sudden steering movements
R
brake carefully
Driving on flooded roads
!
Bear in mind that vehicles travelling in front
or in the opposite direction create waves. This
may cause the maximum permissible water
depth to be exceeded.
These notes must be observed under all cir-
cumstances. You could otherwise damage
the engine, the electronics or the transmis-
sion.
If you must drive on stretches of road on which
water has collected, please bear in mind that:
R
in the case of standing water, the water level
must be no higher than the lower edge of the
vehicle body
R
you should drive no faster than walking pace
Off-road fording
!
Under no circumstances should you accel-
erate before entering the water. The bow
wave could cause water to enter and damage
the engine and neighbouring assemblies.
!
Do not open any of the vehicle's doors while
fording. Otherwise, water could get into the
vehicle interior and damage the vehicle's
electronics and interior equipment.
i
You may only drive through fresh water.
R
Observe the safety notes (
Y
page 119) and
general notes (
Y
page 119) on driving off-
road
R
Establish how deep the water is and the char-
acteristics of the body of water before fording
R
Switch off automatic climate control
R
Vehicles with auxiliary heating/ventila-
tion: switch the auxiliary heating/ventilation
off
R
Shift the transfer case to the LOW RANGE
off-road driving position (
Y
page 124)
R
Engage the differential locks if necessary
(
Y
page 119)
R
Avoid high engine speeds
R
Enter and exit the water at a flat place and at
a steady walking pace
R
Drive slowly and at a constant speed through
the water
R
Ensure that a bow wave does not form as you
drive
R
Do not stop and do not switch off the engine.
Water offers a high degree of resistance, the
ground is slippery and, in some cases, unsta-
ble. Therefore, it is difficult and dangerous to
pull away in water
R
Clean any mud from the tyre tread after ford-
ing
R
Apply the brakes to dry them after fording
Driving tips
117
Driv
ing
and
parking
Z