Meler PS200, Инструкция по эксплуатации, Страница: 65 / 100

4-31
MA-5066-ENG PS200 DRUM MELTER MANUAL MELTER OPERATION
Put the PTFE-coated collection pan in place. Slowly lower the melting platen
using the bimanual control, until the seal is inserted inside the drum.
From this point on, the platen will move down automatically. Wait until the
adhesive comes out of the purge hole. Make sure that there is no air trapped
in the drum.
Place the rod in the purge hole. To do so, introduce the rod one level down
from the protection zone, push down and turn it 1/4 turn to the right.
Clean the PTFE-coated collection pan (the cleaning process is much easier
once the pan has cooled, as you are able to remove all of the solidified
adhesive).
Activate the pump green button. The system is ready to operate.
Removing the empty drum
A warning (‘Platen down’ button light blinking) on the control panel or an
external signal to the light tower or the main machine informs you that drum
is empty. When this happens, the pump will remain deactivated.
You can activate the pump manually pushing continuously the green button to
assure the drum is completely empty (althought the system stops the pump 3
min after the empty drum sensor is activated for that reason).
Removing the drum with manual aeration
Remove the rod from the purge hole. To do so, turn it 1/4 turn to the left and
pull up (1). Now, the rod will up a level and will be in the protection zone. To
remove the rod completly, turn it 1/2 turn to the left or right and pull up (2).
1/2 1/2
2 2
1/4 1/4
1 1
1/4 1/4