Meler PS200, Инструкция по эксплуатации, Страница: 38 / 100

FOCKE MELER GLUING SOLUTIONS, S.A.
4-4
MELTER OPERATION
Displaying the temperature for each component
The temperature may be displayed for each component (platen, each hose and
applicator) by selecting the component with the cursor.
Press the left-right arrow until the desired component is displayed.
After 10 seconds, the display will return to the default component (the platen).
If you wish to keep the component displayed permanently, press and hold the
left-right arrow for 2 seconds while selecting the chosen element.
For units that have one pump installed, the display sequence is the following:
pump manifold<—platen<—hose1<—applicator1<—...<—hose4<—applicator4
pump manifold—>platen—>hose1—>applicator1—>...—>hose4—>applicator4
To remove a component from permanent display, simply press either of the
left-right arrows.
Alarm displays
PS2000 drum melter equipment tell the user when a malfunction has
occurred in the unit, sending warning messages that may be seen on the
control panel display.
When an alarm appears, the control unit takes a series of steps to protect the
unit. Simply correct that malfunction and the control unit will reactivate the
equipment functions.
Standby function does not generate any alarm.
If a temperature sensor is broken, the system heats all the elements except
the one where the failure is located.
In case of overheating the system cuts off inmediately the damaged element.
After three minutes if the failure continues all the system will be shut down.
After repairing the failure the system starts heating normally.