Meler PS200, Инструкция по эксплуатации, Страница: 40 / 100

FOCKE MELER GLUING SOLUTIONS, S.A.
4-6
MELTER OPERATION
• Overheating value: 25°C.
• Standby value: 40%.
• Delay time: 10 min.
• Timetable programs: OFF.
The general process for adjusting the temperatures of each components is
described below.
1. Select the component whose value you wish to modify using the left-
right arrow.
The corresponding LED will blink rapidly.
2. Select the desired set point temperature value with the up-down arrow.
Below 40°C the set point value displays ‘OFF’ canceling the heating of
that element.
3. After ten seconds, the LED will stop blinking and the display will show
the platen’s set point temperature value by default, saving the modified
data.
This simple procedure should be repeated for each of the components whose
set point temperature value you wish to modify.
Programming the applicator parameters
The access to the parameters is performed from the special menu. Simulta-
neously press the buttons with the clock symbol and the down arrow to enter
this menu. The navigation order is as follows:
Function
Symbol on the dis-
play
Default value
Selects the temperature unit to display ºC - ºF ºC
Programs overheating 20 ºC
Programs the temperature for the STANDBY mode 40%
Delay time to activate the Pump F 10 minutes
Activates and deactivates the low tank level alarm n OFF
Programs the time span between the ON mode and the STANDBY mode S-1 OFF
Programs the time span between the STANDBY mode and the OFF mode S-2 OFF
Programs the Password for parameter protection PAS 000
Displays the total hours of service t 00000
Programs the partial filter change counter tP 1000