Meinberg M900, Руководство по эксплуатации

Страница: 62 / 170

The WEB interface
Connect to the web interface by entering the following address into the address
field of your web browser:
http://198.168.10.10
(You need to replace 198.168.10.10 with the IP address of your LANTIME). If you
want to use an encrypted connection, replace the
http:// with https:// in the above
address. You may be prompted to accept the SSL certificate of your LANTIME the
first time you are connecting to the system via HTTPS.
In both HTTP and HTTPS mode, you will see the following login screen:
On this start page you see a short status display, which corresponds with the LC
display on the front panel of the LANTIME unit. The upper line shows the operation
mode of the GPS receiver.
In the upper right corner of the LC display the time and time zone can be found,
below that you will find the date and weekday. On the second line the systems reports
the NTP status. During the initial synchronization process a “NTP: not sync”
indicates that the NTP system is not synchronized, this can also appear if the GPS
looses synchronization and the NTP switches back to its “LOCAL CLOCK” time
source. The GPS clock is connected to the LANTIME system internally by using a
serial connection and additionally by using the second pulse. There are therefore 2
reference clocks used by NTPD, the GPS and PPS time source. You will find the two
time sources in the status information of the NTPD. After the NTP is synchronized,
the Display shows “NTP: Offset GPS: x” or “NTP: Offset PPS: x” where “x” is the
actual offset to the GPS or PPS time source.
This page will be reloaded every 30 seconds in order to reflect the current status of
the unit. Please bear this in mind when you try to login and enter your password. If
you do not press ENTER or the Login button within 30 seconds, the user and
password field is cleared and you have to start over again.
62