Medias Mediatrix 1204, Справочное руководство

Страница: 85 / 390

Firmware Download Reference Manual (SIP Version)
Mediatrix 1204 59
LED States
When the Mediatrix 1204 initiates a firmware download, the LEDs located on the front panel indicate the status
of the process.
See “LED Indicators” on page 15 for a detailed description of the LED patterns related to the firmware
download process.
Firmware Download Procedure
The following steps explain how to download a firmware from the web interface.
X
To download a firmware version:
1. If not already done, setup the Image server used to download the firmware (see “Before
Downloading” on page 53 ).
2. Place the firmware to download on the computer hosting the TFTP or HTTP server.
The file must be in a directory under the TFTP root path.
3. If you are downloading via TFTP, be sure that UDP ports 60000 to 60512 inclusively are opened in
your firewall.
4. If not already done, configure the Image path as described in “Setting up the Configuration File
Download” on page 43 .
5. If not already done, configure the image hosts and ports, as well as the transfer protocol, as defined
in
“Firmware Servers Configuration” on page 54 .
TFTP-Specific Messages
Warning
Image transfer of file: xxx from
host: xxx and port: xxx was
closed due to unexpected error
Unexpected error, either internal or on a TFTP
or HTTP connection.
Warning
Image transfer of file: xxx from
host: xxx port: xxx was closed
after timeout
When not receiving TFTP packets for 32
seconds or not receiving a HTTP packet for 15
seconds.
Warning
Image transfer. File: xxx not
found on host: xxx
When receiving TFTP error “NOT FOUND” or
HTTP response #404.
Warning
Image transfer. Access to file:
xxx on host: xxx is unauthorized
When receiving TFTP error “ACCESS” or HTTP
response #401.
Table 41: LED States in Firmware Download
Event LED State
Image downloading and writing Each LED blinks alternately at 1 Hz with 1/4 ON duty cycle.
Warning : Do not turn the Mediatrix 1204 off while in this state.
Image download failed All LEDs blink at the same time at 2 Hz with 50% ON duty cycle for 4
seconds.
Table 40: Firmware Update Syslog Messages (Continued)
Level Message Event
Caution:
When downloading via HTTP, the firmware download server’s port must be 80. You can see the
actual port assigned in the Status section of the Firmware Download page.
If you are using a DHCP server and it did not provide the proper port, reconfigure it with the proper port or
use a static configuration. See
“Configuration File Server Settings” on page 42 for more details.