Medias Mediatrix 1204, Справочное руководство

Страница: 42 / 390

Chapter 1 - Installation LED Indicators
16 Mediatrix 1204
LED Patterns
Table 10 describes the different states a Mediatrix unit can have and their associated LED patterns.
Table 10: States and LED Patterns
State Description
LEDs Pattern
Ready In Use LAN Power
Booting Follows a hardware start or a reset. See “Booting LED Pattern Description”
on page 17
Normal
Mode “Normal” state of the unit where calls can be
initiated. Each LED has a separate behaviour. See “NormalMode LED Pattern
Description” on page 17
AdminMode Calls are not permitted and maintenance actions
can be performed.
See “AdminMode LED Pattern
Description” on page 18
Recovery
Mode The IP addresses for local host, image server,
syslog server, etc., are temporarily set to known
values. Calls are not allowed. Blink
1 Hz
75% Off Misc.
a
Blink
1 Hz
75%
Reset
Pending Triggered when the Default Settings switch is
pressed and held for at least 2 seconds.
Off Off Off Blink
1 Hz
50%
Reboot
Pending Triggered when the Default Settings switch is
pressed in either the ResetPending or
RecoveryMode Pending states. The unit prepares
for a physical shutdown and restart.
Off Off Off Off
Recovery
Mode
Pending Triggered when the Default Settings switch is held
at start-time or for at least 7 seconds.
Blink
1 Hz
50% Blink
1 Hz
50% Blink
1 Hz
50% Blink
1 Hz
50%
Default
Settings
Pending Triggered when the Default Settings switch is not
released while in RecoveryModePending state.
At run time, if the Default Settings switch is
released within 5 seconds, the unit applies default
settings, otherwise the action is cancelled and the
unit goes back to the Operation Modes state or it
resets.
At start time, the unit stays in this state until the
Default Settings switch is released. The unit then
applies the default settings and restarts.
On On On On
Image
DownloadIn
Progress A software image is downloaded into the unit and
written to persistent storage. LEDs are blinking at 1 Hz 75%, one at a
time , from left to right.
Image
Download
Error Triggered after a failure of an image download
operation. After 4 seconds, the unit restarts. Blink
2 Hz
50% Blink
2 Hz
50% Blink
2 Hz
50% Blink
2 Hz
50%
InitFailed Triggered when bad initialization parameters are
detected and the unit cannot start correctly.
Note : If the network configuration is dynamic, the
unit stays in the Booting state and continues to
query the DHCP until it receives valid values. If
the configuration is static, the LED pattern
indicates that the unit must be reset to default
settings or put into recovery mode for
maintenance and correction of network values.
Off Off Blink
4 Hz
50% Off