Medias Mediatrix 1204, Справочное руководство

Страница: 45 / 390

Default Settings Switch Reference Manual (SIP Version)
Mediatrix 1204 19
Default Settings Switch
The Default Settings switch allows you to:
Cancel an action that was started.
Revert to known factory settings if the Mediatrix 1204 refuses to work properly for any reason
or the connection to the network is lost.
Reconfigure a unit.
At Run-Time
The Default Settings switch can be used at run-time – you can press the switch while the Mediatrix 1204 is
running without powering the unit off. Table 14 describes the actions you can perform in this case.
At Start-Time
The Default Settings switch can be used at start-time – you power the unit off, and then depress the Default
Settings switch and power the unit back on. In this case, the following explains the reset behaviour:
Pressing the Default Settings switch at startup until all the LEDs start blinking restarts the
Mediatrix 1204 in “Recovery Mode”.
Pressing the Default Settings switch at startup until all the LEDs stop blinking and remain ON
applies the “Factory Reset” procedure. This feature reverts the Mediatrix 1204 back to its
default factory settings.
See “LED Indicators” on page 15 for a detailed description of the LED patterns related to the Default Settings
switch.
Table 14: Default Settings Switch Interaction
Default Settings
Switch Pressed
for:
Action Comments
LEDs Pattern
Ready In Use LAN Power
2 to 5 seconds Restarts the
Mediatrix 1204 No changes are made to
the Mediatrix 1204
settings. Off Off Off Blink
5 to 10 seconds Restarts the
Mediatrix 1204 in
Recovery Mode Sets the Mediatrix 1204
IP address to its default
value in the MIB and
restarts the unit. Blink Blink Blink Blink
a
a. Synchronized blinking at 2 Hz (50% duty cycle).
10 to 15 seconds
b
b. You can disable the Factory reset procedure to avoid users deleting the existing configuration. See “Disabling the Factory Re-
set” on page 22 for more details.
Restarts the
Mediatrix 1204 in
Factory Reset Deletes the persistent
MIB values, creates a
new configuration file
with the default factory
values, and then restarts
the unit. On On On On