Model: MTS200 (1U)
Doc. Ref. no. : m08/om/201
Issue no. : 03
User’s Manual
Page 82 of 195
Page 82 of 195
Note:
SSH and TELNET
Communication will get disconnected and console application “
start
”
code will
stop
whenever operator will change the Ethernet network settings parameters
by using SAVE option using the start program.
So, it is necessary that user should again connect MTS200 by SSH or TELNET
communication with the applicable IP address and start the console program
“/usr/sbin/start
” again.
Below table provide each parameter description for Ethernet0 network parameters.
Command Parameter
Applicable
Value
Description
1
Eth0
IPv4
DHCP
Service
0 / 1
To enable DHCP on eth0 network.
Configure this parameter will enable
eth0 to acquire dynamic IPv4 address
from DHCP server in network. This
mode is mainly helpful whenever
MTS200 is connected in network for
first time before installation complete.
If DHCP server is not present,
configur
e this as “0”.
Setting eth0 to DHCP will make static
configuration of IPv4 eth0 network
address meaningless.
Default: 1
2
Eth0 IPv4 Address
xxx.xxx.xxx.xxx This is v4 format IP address for eth0
port.
Default: 0.0.0.0
3
Eth0 IPv4 Gateway
xxx.xxx.xxx.xxx This is v4 format gateway address for
eth0 port.
Default: 0.0.0.0
4
Eth0 IPv4 Netmask
xxx.xxx.xxx.xxx This is v4 format subnet mask address
for eth0 port.
Default: 255.255.255.0
5
Eth0 IPv6 Autoconf
0 / 1
To enable Autoconf on Eth0 network.
Configure this parameter will enable
eth0 to acquire IPv6 address from
network. This mode is mainly helpful
whenever MTS200 is connected in
IPv6 network for first time.
Setting eth0 to Autoconf will make
static configuration of IPv6 eth0
network address unusable and will be
replaced by automatically acquired
IPv6 addresses.
Default: 1
6
Eth0 IPv6 Link-Local
Address
Non-
configurable
Eth0 will have this address whenever
IPv6 service is enabled and link for
Eth0 is live.
Default : ::
7
Eth0 IPv6 Address
Valid
IPv6
address
This is v6 format IP address for eth0
port.
