Model: MTS200 (1U)
Doc. Ref. no. : - m08/om/201
Issue no.: 03
Page 75 of 195
User’s Manual
reach
= The value displayed in column reach is
octal
, and it represents the
reachability register
. One
digit in the range of 0 to 7 represents three bits. The initial value of that register is 0, and after every
poll that register is shifted left by one position. If the corresponding time source sent a valid response,
the rightmost bit is set.
During
a
normal
startup
the
registers
values
increment
in
stages
as
per 0, 1, 3, 7, 17, 37, 77, 177, and 377.
delay
= this indicates the delay (In milliseconds) in ntp query and response
offset
= time difference (in milliseconds) between client and ntp server.
jitter
= variance of time offset (in milliseconds).
9.2.3
SNMP Settings:
MTS200 SNMP parameters required to configure MTS200 as SNMP agent can be configured via console
based configuration utility through serial console port on front panel, Telnet, SSH mode as well as
through Webserver mode.
In this section, method to configure MTS200 as SNMP agent for v1/v2 or v3 and steps to configure V3
authentication will be described via console based configuration utility.
To configure MTS200 as snmp agent, user need to enter SNMP mode from main menu in configuration
utility as described below.
After user enters in SNMP mode, Option “1” will display all current SNMP settings and Option “2” will
allow user to configure SNMP parameters.
Refer below image for Option “1” in SNMP menu which represents list of all applicable SNMP agent
parameters.
