Model: MTS200 (1U)
Doc. Ref. no. : m08/om/201
Issue no. : 03
User’s Manual
Page 42 of 195
Page 42 of 195
9 Unit Setup Configuration
mas
TER
T-Sync
Model MTS200
setup can be done using front panel keypad buttons or front panel RS-
232 based serial console or via Ethernet port eth0 or eth1 using Telnet, SSH, webserver and SNMP.
Keypad options provided all basic general settings, network settings for eth0 and eth1 port, network
services configuration, GPS receiver related settings and limited NTP server settings.
Complete device configuration settings is provided through console based configuration utility (named as
“
start
” application file) which can be run through front serial console or Telnet or SSH. Also, webserver
and SNMP management in MTS200 provides complete device configuration facility.
9.1 Keypad based configuration
mas
TER
T-Sync
Model MTS200
can be configured for parameters related to serial port COM2, time
Format on LCD, Ethernet network settings for eth0 and eth1 port, NTP server configurations, GPS
receiver, manual time as well as Events period through its 8 key keypad on device front panel. Below are
few key parameters which can be configured through keypad.
The COM2 output communication parameters baud rate, number of stop bits and parity.
Serial frame on COM2 port at rear panel of device i.e. NGTS / T-Format/ GPGGA / GPZDA.
The LCD Display Format includes Hour Mode and Time Format (UTC/LOCAL), 12Hour/24 Hour
mode.
Standard Event Mode can be either configured for event per minute or event per hour.
Configuring four additional Event‟s period & Event On time.
Network settings include DHCP service, IP address, subnet mask, default gateway for each
Ethernet port as well as eth0, eth1 can be enabled or disable using UP/DOWN option.
Configuration of various network services such as Telnet, SSH, SNMP, HTTP, HTTPS, FTP.
NTP server settings include local clock service, local clock stratum during device UNLOCK and
NTP service start/stop option.
Calendar settings include manual time, universal time-zone and Daylight Saving time options.
On IRIG o/p port, user can configure it for either IRIG-B122/120 or IEEE-1344 format and with
UTC/LOCAL time option in IRIG frames.
The user can also reset entire unit using RESET UNIT option.
Factory default/Restore of all parameters of GENERAL Settings, NTP settings, SNMP Settings,
Ethernet network settings.
Configuration of display parameters rate for second line on LCD display.
Figure 9-1 Front Panel Keypad Layout
KEY
FUNCTION
MENU
For Entering into Configuration mode.
HELP
To Display help about every parameter configurations.
OK
To save the final Configurations.
ESC
To come back into Run mode.
