Model: MTS200 (1U)
Doc. Ref. no. : m08/om/201
Issue no. : 03
User’s Manual
Page 50 of 195
Page 50 of 195
*
:
Cursor will start blinking once user enters this mode by pressing “OK” key. To change specific digit,
use “UP” / “DOWN” arrow keys and to change the position of blinking cursor use “LEFT” / ”RIGHT” arrow
keys. UP/DOWN arrow keys will update the digit on which cursor is blinking.
After value is edited, press “OK” again to save the parameter. After user presses “OK” key, user will
return to main menu again. User can switch between EVENT1, EVENT2, EVENT3 and EVENT4 menu
using “LEFT” and “RIGHT” key and follow above steps to configure the parameter.
CALENDER SETTINGS:
User can set the internal clock time of MTS200 device in UNLOCK condition only. The internal clock time
setting may be required when the internal RTC battery backup is drained and internal RTC reset to its
default time. In such case, NTP output will not be in sync with actual time. So, if user needs correct time
on all outputs In such condition, it is recommended to set the internal clock time [in UTC] first and then
use all outputs of MTS200 for clients devices. Whenever user sets the internal clock time, GPS receiver is
configured with new entered clock data and ntp service is restarted automatically.
