Model: MTS200 (1U)
Doc. Ref. no. : - m08/om/201
Issue no.: 03
Page 65 of 195
User’s Manual
USB Menu
User can enter in this menu only if USB Pendrive is connected to USB port of MTS200 at front panel. If
USB Pendrive is not connected, MTS will blink "NO DEVICE DETECTED". User can do following
operations:
1) Firmware Update
2) Configuration Files Update
3) Configuration Files backup to USB
Using options 2 and 3, user can configure same settings in number of MTS200 devices.
*
: MTS will be reboot after copying respected files from USB device to MTS for it's operation with new
firmware/configurations.
Note:
To update configuration files, files should be kept
in a folder named “MTS200” in USB
Pendrive. This folder should be present in USB device.
Configuration files backup to USB option will transfer configuration files to
“MTS200”
folder in USB device.
In any option if respected files are not found in USB device, MTS200 will display "FILES
NOT FOUND" message and if USB stick is not found, "NO DEVICE DETECTED" message
will be display on LCD.
In case of firmware update, files should be kept in compressed format with named
mts200_boot.tar. Make sure that final updated files are present in the mts200_boot.rar
INFORMATION
Password of configuration through keypad and password of configuration
through serial terminal are independent.
It is operator‟s responsibility to remember the configured password if it is
changed from factory set password.
It is necessary to press OK key after changing any previous configuration
through keypad, failing of which the particular parameter will restore to its
previous setting.
