Marvelmind Mini-RX, Руководство по эксплуатации

Страница: 108 / 251

108
Update all the beacons
-
You need Inverse Architecture SW (go to marvelmind_SW_ xxx_xx_xx \Software_ia )
-
Run the Dashboard and update the SW for all beacons and modem using Dashboard => Firmware
=> Choose the file => Program
-
If you see the message “Not found modem connection to computer through USB” in the Dashboard
or your PC does not recognize beacons/modem, it usually means that the STM32 driver is not
installed. To install the driver, download it with link at top window in the Dashboard and run the
installation file, then click on the link under and install the driver
Ensure that:
-
You are programming the
modem’s SW to the modem and the beacon’s SW to the beacon
-
You are using SW for 4.9, if you have HW v4.9; and you have the SW from the same SW pack, i.e.,
the Dashboard SW, modem SW, and beacon SW must be from the same SW pack. Don’t mix SW
releases
If SW flashed SUCESSUFLY, MOVE DIRECTLY TO 6.1.6. If you have some
problems with HEX programming, use DFU programming:
DFU programming or SW uploading is used when HEX SW uploading in the Dashboard
cannot be used. For example, when you are updating from a very old SW version or
when the SW includes major changes to the system and the only possible way to update
the SW is via DFU programming
-
After the DFU SW upgrade, futures SW upgrades can be done in a regular manner via the
Dashboard
-
To start programming, move the beacon’s DIP switch to the DFU programming mode, as described
in the paragraph on
DIP switch modes
-
Download the latest SW package , unzip it, and select the proper version of the SW for your HW and
for your frequency variant. Remember that for DFU programming, you should use DFU SW (DfuSe),
not
Dashboard’s .hex file
-
Download DfuSe
-
Here you will find different versions of DfuSe. v3.0.4 or v3.0.5, whichever works the best for your
Windows:
DfuSe v3.0.4 or DfuSe v.3.0.5
DFU Programming:
-
Put DIP switch into Power = ON , DFU = ON ( DIP switch in Mini-RX and
situated inside the body. To switch it, carefully disassemble the body )
-
Connect the beacon via USB to your PC.
-
Run DfuSe.