Märklin Central Station 3, Руководство пользователя

Страница: 62 / 235

22
We need the turnout in a horizontal
alignment for the planned track diagram
control screen. We will therefore rotate it
90 degrees: First, we mark the turnout by
tapping briefly on it. You will see the light
blue circle again surrounding the turnout.
Then we tap again – this time specifically
on the double arrow on the edge of the
turnout – and hold the finger pressed down
on it. The arrow is now shown outlined in
blue (left image).
The turnout is now in the rotation mode . You
can now move your finger up and down. The
turnout will rotate according to the move-
ment of your finger. The current angle for the
turnout will be shown on the turnout symbol.
Stop at 90 degrees.
Tip: The farther from the turnout you move
your finger on the screen, the slower the
rotation will be: The intended angle can be
set more easily this way.
Rotating Solenoid Items: The Rotation Mode
We need turnout „W 2L“
in the lower left section of
the board in order to get
closer to the desired track
diagram. The same steps
are needed for this as
described above: So, pull
the turnout to the lower left
section of the board (left
image), activate the rotation
mode and rotate the turnout
in a horizontal direction to
an angle as shown of 90
degrees (right image).
Adding Track Laying Items
We need track path items in order to generate a visually
appealing track diagram. These are purely decorative
elements without a function. Open a drop-down menu by
means of the „Add“ button in the tool bar. Here you will
select „Track laying items”. In the menu that follows, tap
four times on „Track Route” and once on „Bumper” since a
storage siding is also part of the desired track diagram. Tap
again on „Add” or on an area outside of the menu in order
to close it.
Tip: You can add other possible track building items such as
tunnels, bridge retainers, and bridges (left image) using the
same process. All other items from turnouts to S88 contacts
can be added in this way and at the same time, they can be
put in the item list.
The track path items and
the track bumper are
automatically put on the
activated board by the
add function, in our case
the „Maerklin”.
The items added always appear on
the board in a set alignment. Since
we need a horizontal track path item
for the next step, we have to realign
it and rotate it to a horizontal position
(Rotation Mode, see Page 22).