![background image](http://html.mh-extra.com/html/makita/ebh341r/ebh341r_original-instruction-manual_223041018.webp)
18
5) Keep the engine level, and feed new oil up to the edge of the oil refill port.
In refill, use a lubricant refill container.
6) After refill, securely tighten the oil gauge. Insufficient tightening of the oil
gauge will lead to oil leakage.
CHECKING THE SPARK PLUG
Only use the supplied universal wrench to remove or to install the spark plug.
–
The gap between the two electrodes of the spark plug should be 0.7-0.8 mm
–
(0.028”-0.032”). If the gap is too wide or too narrow, adjust it. If the spark plug
is clogged with carton or fouled, clean it thoroubhly or replace it.
CAUTION: Never touch the spark plug connector while the engine is running
(danger of high voltage electric shock).
CLEANING OF AIR CLEANER
DANGER: INFLAMMABLES STRICTLY PROHIBITED
Interval of Cleaning and Inspection: Daily (every 10 operating hours)
Turn the choke lever to the full close side, and keep the carburetor off from
–
dust or dirt.
Remove the air cleaner cover-fixing bolts.
–
Pull the cover lower side and detach the air cleaner cover.
–
If oil adheres to the element (sponge), squeeze it firmly.
–
For heavy contamination:
–
1) Remove the element (sponge), immerse it in warm water or in water-
diluted neutral detergent, and dry it completely.
2) Clean the element (felt) with gasoline, and dry it completely.
Before attaching the element, be sure to dry it completely. Insufficient drying
–
of the element may lead to difficult startup.
Wipe out with waste cloth, oil adhering around the air cleaner cover and plate
–
breather.
Immediately after cleaning is finished, attach the cleaner cover and tighten it
–
with fixing bolts. (In remounting, first place the upper claw, and then the lower
claw.)
Points in Handling Air Cleaner Element
Clean the element several times a day, if excessive dust adheres to it.
–
If operation continues with the element remaining not cleared of oil, oil in
–
the air cleaner may fall outside, resulting in oil contamination.
Plate
Element (felt)
Fixing bolt
Pick this part and remove the element (felt).
Breather Part
Element (sponge)
Air cleaner cover
0.7 mm - 0.8 mm
(0.028” - 0.032”)
POINTS ON OIL
Never discard replaced engine oil in garbage, earth or sewage ditch. Disposal of oil is regulated by law. In disposal, always follow the
–
relevant laws and regulations. For any points remaining unknown, contact Authorized Service Agent.
Oil will deteriorate even when it is kept unused. Perform inspection and replacement at regular intervals (replace with new oil every
–
6 months).
Содержание EBH341R
Страница 149: ...149 ...
Страница 150: ...150 ...
Страница 151: ...151 ...
Страница 152: ...Makita Corporation Anjo Aichi Japan 885161A930 www makita com ALA ...