![background image](http://html.mh-extra.com/html/makita/ebh341r/ebh341r_original-instruction-manual_223041019.webp)
19
Grease hole
SUPPLY OF GREASE TO GEAR CASE
Supply grease (Shell Alvania 2 or equivalent) to the gear case through the
–
grease hole every 30 hours. (Genuine MAKITA grease may be purchased
from your MAKITA dealer.)
REPLACEMENT OF FUEL PIPE
CAUTION: INFLAMMABLES STRICTLY PROHIBITED
Interval of Cleaning and Inspection: Daily (every 10 operating hours)
Replacement: Annually (every 200 operating hours)
Replace the fuel pipe every year, regardless of operating frequency. Fuel
leakage may lead to fire.
If any leakage is detected during inspection, replace the oil pipe immediately.
INSPECTION OF BOLTS, NUTS AND SCREWS
Retighten loose bolts, nuts, etc.
–
Check for fuel and oil leakage.
–
Replace damaged parts with new ones for safety operation.
–
CLEANING OF FUEL FILTER
WARNING: INFLAMMABLES STRICTLY PROHIBITED
Interval of Cleaning and Inspection: Monthly (every 50 operating hours)
Suction head in the fuel tank
The fuel filler (1) of the suction head is used to filler the fuel required by the
–
carburetor.
A periodical visual inspection of the fuel filter is to be conducted. For that
–
purpose open the tank cap, use a wire hook and pull out the suction head
through the tank opening. Filters found to have hardened, been polluted or
clogged up are to be replaced.
Insufficient fuel supply can result in the admissible maximum speed being
–
exceeded. It is therefore important to replace the fuel filter at least quarterly to
ensure satisfactory fuel supply to the carburetor.
SUPPLY OF GREASE TO THE FLEXIBLE SHAFT
Pull out the flexible shaft from the flexible lining for every 20 hours, and apply
–
grease on the flexible shaft.
The flxible shaft may be broken if no grease is applied.
–
Any maintenance of adjustment work that is not been included and described in this manual is only to be performed by Authorized Service
Agents.
Flexible liner
Flexible shaft
Apply grease
Fuel pipe
Fuel filter (1)
Hose clamp
Fuel pipe
CLEANING OF PARTS
Keep the engine always clean.
–
Keep the cylinder fins free of dust or dirt. Dust or dirt adhering to the fins will cause seizure.
–
REPLACEMENT OF GASKETS AND PACKINGS
In reassembling after the engine is dismounted, be sure to replace the gaskets and packings with new ones.
Содержание EBH341R
Страница 149: ...149 ...
Страница 150: ...150 ...
Страница 151: ...151 ...
Страница 152: ...Makita Corporation Anjo Aichi Japan 885161A930 www makita com ALA ...