Mahr Digimar 817 CLM, Руководство по эксплуатации

Страница: 34 / 152

34
Mahr GmbH • Digimar 817 CLM
3.3 Start a measurement procedure with the speed
Description / Sequence Symbols / Pictures
3.3.1 Motorized positioning of the probe
By the activating and holding down either of the two keys the motor
driven measuring carriage will travel in the required direction. Once the
button is released the measuring carriage will stop.
3.3.2 Contacting a plane
Briefly press (<0.5 sec.) either one of the keys to start the measuring
function, the motor driven carriage will travel to the plane to be
measured. Once the plane has been contacted and the measured value
has been accepted an acoustic signal will be emitted (beep) and the
measured value will be shown in the display.
3.3.3 Switching between contacting a plane / bore
– Press the shift key on the base plate
– If the „Contact a plane“ is active the following symbol will
appear
– If the „Contact a bore“ is active the following symbol will
appear
( )
<0.5 s
contact
from
below
<0.5 s
contact
from
above
keys
With the speed keys that are located on the base, the operator can
move the motor driven measuring carriage comfortably into the desired
position; in addition a measurement can be started by briefly pressing a
key. This simplifies the measurement of large workpieces that cannot be
easily or are too heavy to be moved into position; the operator has both
hands free to operate the measuring instrument (air pump and the
speed keys), thus measuring the workpiece in one run.