R e c h a r g e a b l e F l a s h l i g h t
MR Rev.1 8/03
421-000-438
14
STEP 21
Push the flashlight into the tool holder until
the HEAD (14) stops at the holder. Push the
plunger down into the switch hole.
STEP 22
Insert the spanner wrench into the tool
holder and rotate until the pins in the holder
fall into the holes in the CHARGER MODULE
(9). Tighten the CHARGER MODULE (9)
(clockwise) as tight as possible.
STEP 20
Pull the plunger on the tool holder up and
place the flashlight, CHARGER MODULE (9)
end first into the front of the tool holder.
Make sure the switch hole is lined up with
the plunger.
STEP 23
Insert the silver ringed portion of the
BARREL (16) into the rear of the tool
holder and screw it into the CHARGER
MODULE ( 9) (clockwise), tighten by
hand as tight as possible.
