R e c h a r g e a b l e F l a s h l i g h t
MR Rev.1 8/03
421-000-438
24
REPLACING THE CIRCUIT
BOARD - STEP 10
Before installing the new CIRCUIT BOARD
(3), test it to make sure the board is good.
Plug the board into a power converter and
touch the two spring loaded pins on the
board together, the LED should light if the
board is good.
STEP 11
Hold the clamps of the CHARGER CRADLE
(1) together as shown in fig.1, this will
create an opening at the base of the cradle
as shown on fig.2. If the clamps at the base
are not open you will not be able to get the
SPRING CLIP (2) installed.
STEP 9
The SPRING CLIP (2) will probably pop out, if
not, leave the SPRING CLIP (2) in the
CHARGER CRADLE (1).
FIG. 1
FIG. 2
