MacKay Guardian SOLO, Руководство по эксплуатации и обслуживанию

Страница: 63 / 79

MacKay Guardian™ Solo
Operation and Maintenance Guide, v. 1.5
3)
Unplug the Mag Head reader from the MCB connector J5 (see illustration)
• Figure 30 – J5 - Magnetic Head Connector on MCB
4)
Lift out the card guide. Reassembly is in the reverse order.
5)
Prior to fully tightening the card guide/Mag Head assembly retaining screws, insert a test
card fully into the solo meter. This ensures that the card guide & chip card reader are in
alignment. Tighten the four retaining screws and insert and remove the test card a few
times to ensure that the card can be inserted freely without binding/stiffness.
9.10 Replacing a Chip Card Reader Board
1)
Disconnect power from the MCB - remove plugs J11 & J12 (see Figure 28)
2)
Remove the three chip card reader board retaining screws
• Figure 31 - chip card reader board retaining screws
53