MacKay Guardian SOLO, Руководство по эксплуатации и обслуживанию

Страница: 66 / 79

MacKay Guardian™ Solo
Operation and Maintenance Guide, v. 1.5
5)
Lift the enforcement display assembly up slightly and then disconnect the MCB to
enforcement display ribbon cable of the MCB by depressing the eject tabs in the mating
connector
6)
Lift the enforcement display assembly clear
7)
Insert/adjust/repair/replace the rear enforcement display assembly as necessary
8)
Reassemble the rear enforcement display assembly in the reverse order described
above. Ensure that the ribbon cable is reconnected and the ribbon cable is positioned
such that it does not interfere with the spring loaded movement of the enforcement
display (see illustration).
9.13 Replacing the Front Display
1)
Remove the MCB assembly as previously described
2)
Remove the rear enforcement display assembly as previously described
3)
Gently slide the front display board assembly upwards until it clears the MCB
• Figure 35 - Front Display Board Ribbon Cable
4)
Unplug the front display board ribbon cable from the MCB by pressing on the ejector tabs
on the MCB connector. Note the position of the ribbon cable (see illustration)
5)
Inspect/repair/replace the front display board assembly as necessary
6)
Re-assemble by following the above in the reverse order. Ensure that the ribbon cables
for both the front & rear display assemblies do not interfere with the spring mounted
movement of the rear enforcement display.
56